mypros+
Model reference

Magic Chef 82LS-2K

Cooktop

2 documents35 error codes4 service modes

Available documentation

Tech Sheet

  • TECH SHEET - 9758011 - Rev A12 pg
    Covers this model
  • Wiring Diagram - W10873901 -Rev A.pdf2 pg
    Covers this model
MyPros+ Max

Diagnose your Magic Chef 82LS-2K.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (35)

CodeMeaning
F0 E0No failure (default code).F1 E0Internal error.F1 E1Internal error.F1 E2Internal error.F1 E3Internal error.F1 E4Internal error.F1 E5Internal error.F1 E6Internal error.F1 E7Internal error.F1 E8Internal error.F1 E9Internal error.F2 E0Stuck key (shorted key) on keypad.F2 E1Keypad disconnected.F3 E0Main oven sensor open (top oven sensor opened).F3 E1Main oven sensor shorted (top oven sensor shorted).F3 E2Meat probe shorted.F3 E4Bottom oven sensor open (bottom oven sensor open).F3 E5Bottom oven sensor shorted (bottom oven sensor shorted).F3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F4 E2Over temperature during cook mode (temperature runaway).F4 E3Over temperature during clean mode (temperature runaway).F4 E7Over temperature cavity 2 (temperature runaway error).F5 E0Door latch mismatch (door and latch switches do not agree).F5 E1No operating latch / latch not operating.F5 E2Door switch fault.F5 E4Latch switch fault.F5 E7Unlock door error / cannot unlock door.F6 E4Lost communication between display board and power board.F6 E5Cancel key error.
View all 35 error codes
Memory FailureControl board memory/software fault detected during Field Service Test; Heated…Motor high currentWash motor drawing excessive current detected during Field Service Test; Normal…Motor low currentWash motor drawing insufficient current detected during Field Service Test…Thermistor failureThermistor fault detected during Field Service Test; Heavy Wash LED flashes…Turbidity Sensor failureTurbidity sensor fault detected during Field Service Test; Rinse Only LED…

Service modes (4)

  • Diagnostic mode["Press the Cancel key to place the range in an idle state.","Press the Cancel and Start keys in…
  • Field Service TestPress the Heavy Wash key 5 times followed by the Start key within 6 seconds.
  • Manual Function TestPress the Normal Wash key 5 times followed by the Start key within 6 seconds
  • Sales Floor Demo ModePress Extra Rinse keypad 5 times within 6 seconds.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef cooktop models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax