mypros+
Model reference

Magic Chef 31FN-10K-49

Range

1 document15 error codes21 service modes

Available documentation

Tech Tip

  • Instruction Sheet - 397921112 pg
    Covers this model
MyPros+ Max

Diagnose your Magic Chef 31FN-10K-49.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (15)

CodeMeaning
:Flashing colon indicates a power failure has occurred.3 beepsThermistor or wire harness is either shorted or open, detected when Push to…E1Thermistor is open (open circuit detected).E2Thermistor has shorted (short circuit detected).E3User interface (keyswitch) or software mismatch between control panel/touchpad…F1Internal H.V./L.VF2Touch panel failure.F3Internal H.V./L.VF3HHumidity sensor failure.F4Internal H.V./L.VF5Touch panel failure.F6MW relay (Relay 4903) failureNTC OPEN, CALL FOR SERVICEHF NTC thermistor is open.NTC SHORT, CALL FOR SERVICEHF NTC thermistor is shorted.PFPower failure occurred while the dryer was running.

Service modes (21)

  • Console Switches and Indicators Test["Enter Diagnostic Test Mode (see above).","Press each touchpad individually; each press should…
  • Control Panel Deactivation (RCS10MP P1140412M / RCS10MPS P1324901M)["Open oven door, and close oven door.","Press TIME ENTRY pad.","Press 1, 3, 5, and 7 pad in…
  • diagnostic1. Set configuration
  • Diagnostic Test Mode["Unit must be in Standby (unit plugged in, display off).","Alternately press the Less Time ▼ and…
  • diagnostic_test["Begin with a fully assembled dryer connected to a known good power source.","Set Door
  • holiday_modePress the Holiday Mode key
  • Less Dry Test["Begin with a fully assembled, empty dryer with clean lint screen connected to a known good power…
  • less_dry_test["Begin with a fully assembled, empty dryer with clean lint screen connected to a known good power…
  • Programming mode (RCS10 P1140411M)["Open oven door.","Press and hold pad 1 for approximately 15 seconds.","Signal sounds and display…
  • Programming mode (RCS10MP P1140412M / RCS10MPS P1324901M)["Open oven door.","Press and hold pad 1 for approximately 15 seconds.","After 15 seconds, signal…
  • Programming mode (RFS9B, RCS10, RCS10MP, RCS10MPS, RFS10S, RFS12MPS, RFS12S - 2000/2002 models)["Open oven door.","Press and hold pad 1 for approximately 5 seconds.","After 5 seconds, signal…
  • Sales Demo ModePress down-arrow, buzzer, down-arrow, buzzer keypads within 5 seconds.
  • sales_demonstrationPress and hold the Max Cool and Power On/Off keys for 2 seconds.
  • Self-Diagnostic / Touch Panel Test Mode["Press and hold CANCEL•OFF while opening the door.","While still holding the CANCEL•OFF button…
  • Self-diagnostic test mode (Touch Panel and PCBA Test)["Press and hold the OFF/CANCEL button while opening the door.","While still holding the OFF/CANCEL…
  • Service Diagnostics TestWith power applied, within 5 seconds alternately press the up (∆) arrow and buzzer keypads each…
  • Stuck Keypad TestWith power applied, press and hold any keypad on the control panel until all of the control panel…
  • Touch Panel and PCBA Self-Diagnostic Test Mode["1
  • User Options mode (RCS10MP P1140412M / RCS10MPS P1324901M)["Open oven door.","Press and hold pad 1 for approximately 15 seconds.","Press hidden…
  • User Options mode (RFS10SW2, RFS12SW2)["Open oven door.","Press and hold pad 2 for approximately 5 seconds.","After 5 seconds, signal…
  • User Options mode (RFS9B, RCS10, RCS10MP, RCS10MPS, RFS10S, RFS12MPS, RFS12S - 2000/2002 models)["Open oven door.","Press and hold pad 2 for approximately 5 seconds.","After 5 seconds, signal…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass