mypros+
Model reference

Magic Chef D2450-2-2X

Range

1 document28 error codes16 service modes

Available documentation

Tech Sheet

  • TECH SHEET16 pg
    Covers this model
MyPros+ Max

Diagnose your Magic Chef D2450-2-2X.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (28)

CodeMeaning
d1Dryer door sense error on control board or due to power line interference…d12Motor sense error on control board or due to power line interference; cycles…d13Blocked coin 2 or coin drop control circuit failure; coin recognition and price…d16Not receiving communications from installed debit card reader in Enhanced…d4Dryer motor control circuit error; cycles and customer display disabled until…d5Blocked coin 1 or coin drop control circuit failure; coin recognition and…d9Voltage detected below 185 VAC for 8 seconds.F0Default F codeF1Electronic control malfunction.F1-E0Key held down too long, or key is shorted.F1-E1Keypad keytail not connected.F1-E5CANCEL key drive line open.F1E1No voltage detected at the heater relay; possible motor or heater failure or…F2-E0Temperature sensor opened (R=2875 ohm by spec).F2-E1Temperature sensor shorted (R=825 ohm by spec).F3-E2Oven temp too highF3-E3Oven temp too highF3E1Exhaust thermistor is open or shorted (open if temp drops below 18°F / >50k…F3E2Moisture sensor strip 1 is open or shorted (only appears in service diagnostic…F3E3Inlet thermistor is open or shorted (open if temp drops below 18°F / >245k…F3E5Second moisture sensor strip is open or shorted (Quad Sense models only; only…F4-E1Meat probe malfunctionF5-E0Door is open but latch is locked (door switch open indicating open door, latch…F5-E1Self-clean latch will not lock/unlock.F6E1ACU and HMI have not communicated for a specified amount of time.F6E2WiFi Module has not responded for a specified amount of time.FCE1WiFi Module communications lost.PFPower failure occurred while the dryer was running.

Service modes (16)

  • Bake Temperature Offset Adjustment1
  • Cavity Size ProgrammingWithin 60 seconds of power up, press the following touchpads in order
  • Component Activation / Quick Service Cycle (LCD in Door Models)["Enter Service Diagnostic Mode (LCD in Door) first.","From the DIAGNOSTICS HOME screen, scroll…
  • diagnosticEnter set-up mode (remove access door key, turn, and lift to remove access door; unplug dryer, open…
  • Diagnostic Mode["Enter the set-up mode first (see set-up mode entry).","While in any of the set-up codes 1 through…
  • Fahrenheit to Celsius ConversionPress the BROIL pad for 5 seconds
  • Fault Code History RecallPress and hold the '0' key to access previous fault codes
  • helpWhile in special pricing option step 2.XX (or while dAS displays if operating with Maytag Data…
  • Help Mode["Enter the set-up mode first.","Navigate to special pricing option step 2.XX (or while dAS…
  • Key Activation & Encoder Test (Console Models)["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…
  • Service Diagnostic Mode (Console Models)["Ensure the dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…
  • Service Diagnostic Mode (LCD in Door Models)["Ensure the dryer is in standby mode (plugged in with all indicators off).","Open and close the…
  • Service Test Mode (Console Models)["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • set-upInsert access door key, turn, and lift to remove access door
  • Set-up Mode["Insert access door key, turn, and lift to remove access door.","Unplug dryer or disconnect…
  • Software Version Display (Console Models)["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax