mypros+
Model reference

Maytag MCG8000AWW

Dryer

5 documents12 error codes12 service modes

Available documentation

Service Manual

  • Neptune DC Base Manual58 pg
    Covers this model
  • Neptune DC Base Manual58 pg
    Covers this model

Bulletin

  • Technical Bulletin - Hi-Limit Thermostat and Thermal Fuse Relocation1 pg
    Covers this model
  • Technical Bulletin - TDL-0039-B Hi-Limit Thermostat and Thermal Fuse Relocated1 pg
    Covers this model

Service Flash

  • Service Pointer - 8178754 (Long Dry Times)2 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MCG8000AWW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (12)

CodeMeaning
1Lower dryer thermistor short sensed11Upper dryer thermistor short sensed12Upper dryer thermistor open sensed13Upper dryer door circuit failure2Lower dryer thermistor open sensed3Lower dryer door circuit failure6Non-volatile memory problem detected with integrity of parameters stored in…8Stuck buttonh1A temperature increase has not been detected on the lower dryer and the dryer…h11A shaker assembly neutral fault has been detected; shaker relay is de-energized…HPThermistor reading is out of range and the dryer cycle is interrupted.PFA power failure occurred during an active or paused cycle.

Service modes (12)

  • Clear Diagnostic Codes (cd)1) Enter Diagnostic State
  • Diagnostic State["Ensure no dryer cycle is active or paused (press Off to cancel if needed).","On the upper or…
  • Diagnostic State (System Check Mode)From the Normal Program State on the upper or lower dryer half of the keypad, press the Signal (+)…
  • Logic Board Output Self-test (Lo)1) Enter Diagnostic State
  • Membrane Keypad Utility (Pd)1) Enter Diagnostic State
  • Read Sensor Inputs (rd)1) Enter Diagnostic State
  • Reset to Factory Default (rS)["Enter Diagnostic State from upper or lower dryer keypad (Signal (+) + Time Adjust ^ for 5…
  • Reset to Factory Default Conditions (rS)Step 1
  • Sensor Bar Diagnostics (db via rd)1) Enter Diagnostic State ('dd' appears)
  • Sub-system Check (Sc)1) Enter Diagnostic State
  • View Cycle Statistics (cS)1) Enter Diagnostic State
  • View Diagnostic Codes (dL)1) Enter Diagnostic State

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass