Model reference

Maytag MED9000YG2

Dryer

5 documents18 error codes5 service modes

Available documentation

Tech Sheet

techsheet-w10420006-reva_W1042000656 pg
Covers this model
Tech Sheet - W1031551256 pg
Covers this model

Tech Tip

Instruction Sheet4 pg
Covers this model
Instruction Sheet - W10318609- Rev A - Special Handling7 pg
Covers this model

Installation Guide

Instrucciones de instalacion23 pg
Covers this model

MyPros+ Max

Diagnose your Maytag MED9000YG2.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Dryer

AF on my Maytag MED9000YG2

M+

Restricted/low air flow detected that

From Tech Sheet W14143796, p.48:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (18)

CodeMeaning

AFRestricted/low air flow detected that may affect dryer performance.F1E1Indicates a Cycle Control Unit (CCU) problem.F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatch; only…F2E2UI software error; UI cannot read EEPROM software.F3E1Exhaust thermistor is open; temperature drops below 18°F (>50k ohms).F3E2Exhaust thermistor has shorted; temperature above 250°F (<500 ohms).F3E3Inlet thermistor is open; temperature drops below 18°F (>245k ohms)F3E4Inlet thermistor is shorted; temperature above 760°F (<20 ohms)F3E5Inlet and exhaust thermistors are both open; will occur if P14 connector is not…F3E6Moisture sensor strip is open F3E7Moisture sensor strip has shorted F4E1No voltage detected at the heater relay F4E3Restricted air flow detected that may affect dryer performance.F4E4Low L2 voltage (less than 50V) detected at the CCU.F6E1Communication between the CCU and UI has not been detected (UI to CCU).F6E2Communication between the CCU and UI has not been detected (CCU to UI).L2Low L2 voltage (less than 50V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (5)

Component ActivationFrom Service Diagnostics Diagnostics Home screen, select 'Component Activation'
Customer-Focused Dryness Level Adjustment1. Turn cycle selector knob to an automatic cycle. 2. From the Automatic Cycle Main Screen, press…
Quick Diagnostic TestFrom Diagnostics Home screen, select 'Error Diagnostic', then select 'Quick Diagnostic Test'
Service Diagnostics1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
UI Component TestFrom Diagnostics Home screen, select 'Component Activation', then select 'UI Component Test'

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass