Model reference

Maytag MEW9630DS01

Oven

6 documents25 error codes13 service modes

Available documentation

Tech Sheet

Tech Sheet - W10507056 - Rev B32 pg
Covers this model
Tech Sheet32 pg
Covers this model

Service Flash

Technical Service Pointer9 pg
Covers this model

Tech Tip

Instruction Sheet2 pg
Covers this model
installerlabel-w10643344-reva.pdf2 pg
Covers this model

Installation Guide

Installation Instructions28 pg
Covers this model

MyPros+ Max

Diagnose your Maytag MEW9630DS01.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Oven

F1 E0 on my Maytag MEW9630DS01

M+

Oven appliance manager failure.

From Tech Sheet W15548100, p.32:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

F1 E0Oven appliance manager failure.F1 E1Oven user interface failure.F1 E7Internal error on MRC board.F1 E9Internal error on MRC board.F2 E0Keypad disconnected.F2 E1Stuck/shorted key.F2 E2Invalid keypad detected.F2 E3Keypad hardware failure.F3 E0Main oven sensor open or shorted.F3 E1Bottom oven sensor open or shorted.F5 E0Single/double upper oven door and latch switch do not agree.F5 E1Single/double upper oven latch not operating.F5 E3Double lower oven door and latch switch do not agree.F5 E4Double lower oven door latch not operating.F5 E5Upper door switch reads constant high.F5 E6Lower door switch reads constant high.F6 E0Oven user interface lost communication.F6 E1Single/double upper oven F6 E2Single/double upper oven F6 E3Double lower oven F6 E4Oven user interface/appliance manager state mismatch.F6 E5No cavity size command.F6 E6Oven appliance manager F6 E7Lost communication with MWO appliance manager.F6 EBDouble lower oven

Service modes (13)

Auto Test1
Auto Test Mode1
Diagnostics ModePress CANCEL > CANCEL > START.
Error Codes1
Fault Display Reset1
Model Select1
Relay Activation1. Enter Diagnostics Mode (CANCEL > CANCEL > START). 2. Press the quickset pad below Relay…
Software Version1
Status Screen1
Temperature Calibration (Double Oven)1
Temperature Calibration (Single Oven)1
Test Mode (Relay Activation)1
Usage Codes1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass