Model reference

Maytag YMER8600DS0

Range

6 documents16 error codes5 service modes

Available documentation

Tech Sheet

Tech Sheet - W10667174 - Rev A (FR)8 pg
Covers this model
Tech Sheet - W10667167 - Rev A8 pg
Covers this model

Tech Tip

Oven Cleaning Quick Reference Guide2 pg
Covers this model

Installation Guide

Installation Instructions16 pg
Covers this model
Instruction Sheet2 pg
Covers this model

Quick Reference

Quick Reference Manual2 pg
Covers this model

MyPros+ Max

Diagnose your Maytag YMER8600DS0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Range

F1 on my Maytag YMER8600DS0

M+

Internal circuit board failure or A/D

From Tech Sheet W18133340, p.32:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (16)

CodeMeaning

F1Internal circuit board failure or A/D error(s) (F1E0, F1E1, F1E2 on LCC 180/190…F1E0Internal board failure on LCC 180/190 control.F1E1Internal board failure (A/D error) on LCC 180/190 control.F1E2Internal board failure (A/D error) on LCC 180/190 control.F2Shorted key on the control panel (F2E0 on LCC 180/190 display).F2E0Shorted key detected on LCC 180/190 control.F3Oven sensor open circuit or short circuit (F3E0/F3E1 = open/short; F3E2 =…F3E0Oven sensor opened on LCC 180/190 control.F3E1Oven sensor shorted on LCC 180/190 control.F3E2Bake/Broil range over temperature condition.F3E3Clean range over temperature condition.F5Door and door position switch mismatch during clean mode (F5E0/F5E2 on LCC…F5E0Door and door position switches do not agree during Clean mode on LCC 180/190…F5E2Door and door position switches do not agree during Clean mode on LCC 180/190…F9Faulty house wiring or faulty range wiring (F9E0 on LCC 180/190 display).F9E0Miswired house or miswired range on LCC 180/190 control.

Service modes (5)

diagnosticPress CANCEL > CANCEL > START within 5 seconds.
diagnostic_test_modeFrom within diagnostic mode, press the following buttons to test each relay
Diagnostics ModePress CANCEL > CANCEL > START within a 5-second period.
Diagnostics Test Mode (Relay Checks)While in Diagnostics Mode (entered via CANCEL>CANCEL>START), press BAKE to toggle bake relay, BROIL…
Temperature Adjustment ModeStep 1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass