mypros+
Model reference

Maytag YMER8850DS0

Range

6 documents24 error codes15 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10667177 - Rev A (FR)8 pg
    Covers this model
  • Tech Sheet - W10667170 - Rev A8 pg
    Covers this model

Tech Tip

  • Oven Cleaning Quick Reference Guide2 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
  • Instruction Sheet2 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag YMER8850DS0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (24)

CodeMeaning
F1-E0EEPROM communication error.F1-E5Sensor out of range.F1-E7Board thermistor open or short-circuited.F1E0EEPROM communication error within the oven control.F1E5Sensor out of range.F1E7PCB thermistor open or shorted.F2-E0Keypad disconnected.F2-E1Key stuck.F2-E2Cancel key error.F2E0Keypad disconnected from oven control.F2E1Stuck key detected on keypad.F2E2Cancel key error.F3-E0Main oven temperature sensor open or short-circuited.F3-E2Warming drawer sensor open or short-circuited.F3E0Main oven temperature sensor open or shorted.F3E2Warming drawer temperature sensor open or shorted.F5-E0Door and switch mismatch (clean modeF5E0Door and switches do not agree (Clean modeF6-E1BakeF6-E2CleanF6-E3Warming drawerF6E1Over temperature during cook mode.F6E2Over temperature during clean mode.F6E3Over temperature in warming drawer.

Service modes (15)

  • Auto TestEnter diagnostic mode (CANCEL>CANCEL>START), then press up arrow, '+', or '3' to scroll to AUTO…
  • Diagnostics Mode (MRC Control)Press CANCEL > CANCEL > START
  • DISPLAYEnter diagnostic mode, scroll to step 5 (DISPLAY).
  • ENG MODEEnter diagnostic mode, scroll to step 2 (ENG MODE), press START to enter, then press '+'
  • FAULTSEnter diagnostic mode, scroll to step 7 (FAULTS).
  • MRC Control Module Diagnostic ModePress CANCEL > CANCEL > START
  • RELAY USAGEEnter diagnostic mode, scroll to step 8 (RELAY USAGE).
  • Temperature AdjustmentPress OVEN LIGHT for 5 seconds
  • Temperature Calibration AdjustmentPress and hold OVEN LIGHT for 5 seconds
  • TEST MODEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode 3 (TEST MODE)
  • TEST MODE (Relay Control)Enter diagnostic mode, scroll to step 3 (TEST MODE)
  • TEST ON (Relay Checks)Enter Diagnostics Mode (CANCEL > CANCEL > START)
  • TEST ON (Relay Control)Entered immediately upon entering diagnostic mode (CANCEL>CANCEL>START)
  • USAGEEnter diagnostic mode, scroll to step 1 (USAGE).
  • VERSIONEnter diagnostic mode, scroll to step 4 (VERSION).

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass