Model reference
Prodigy EH222
Ice Maker
4 documents10 error codes14 service modes
Available documentation
Service Manual
- Service Manual for Prodigy Eclipse Cuber model EH222 with ECC Condensing Unit52 pg
- ICE Machine Service Handbook58 pg
Bulletin
- Prodigy Cubers Service Bulletins2 pg
Other
- ps 5 6 2007 TXV2 pg
MyPros+ Max
Diagnose your Prodigy EH222.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (10)
CodeMeaning
1Maximum freeze time exceeded; the freeze cycle has taken longer than the…2Maximum harvest time exceeded; harvest cycle continued beyond 3.5 minutes…3Slow water fill; water supply is inadequate and the reservoir did not fill…4High discharge temperature; discharge temperature has exceeded 250 degrees F.5Sump temperature sensor failure.7Discharge temperature sensor failure.8Short freeze cycle; freeze cycle terminated too quickly indicating thin ice…bBin is full; ice level sensor has detected the bin or dispenser is full of ice.ESelf test failed during controller power-up self test.LBoard is locked; the control board has been locked via the lock function.Service modes (14)
- change_descale_notification_interval1. With status light off, press and hold Harvest button for 3 seconds to enter Time to Clean…
- clean_cycle_a_c_series1
- clean_cycle_d_series1
- clear_descale_sanitize_light1
- clear_diagnostic_codeHold Clean and Harvest buttons in for 3 seconds to clear all prior codes.
- clear_diagnostic_codesHold Clean and Harvest buttons in for 3 seconds to clear all prior codes.
- empty_reservoir1
- lock_unlock_controlHold On button for 3 seconds, keep holding, then press and release Off twice.
- recall_diagnostic_code1
- recall_diagnostic_codes1
- reset_controlDepress and release Off, then depress and release On.
- set_descale_interval1. From standby (Status Light Off), press and hold Harvest button for 3 seconds. 2. Display shows…
- set_purge_level1. From standby, hold Off button for 3 seconds and release. 2. Press and release the On button to…
- test_mode1. From standby (Status Light Off), hold Off button for 3 seconds and release. 2. Hold Clean button…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Prodigy ice maker models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax