Model reference
Samsung DV350AGW/XAA
Dryer
11 documents11 error codes15 service modes
Available documentation
Service Manual
- Clothes Dryer Service Manual DV350A* / DV330A*81 pg
- Service Clothes Dryer52 pg
- CLOTHES DRYER SERVICE Manual45 pg
- Clothes Dryer Service Manual DV350A* / DV330A*45 pg
Tech Sheet
- Samsung Dryer DV350R3 Fast Track Manual7 pg
- Fast Track Troubleshooting - Samsung Dryer DV350 Service Data Sheet7 pg
Bulletin
- Door switch change1 pg
- SERVICE BULLETIN - Door switch change1 pg
- Samsung DryerDV520AEP XAA Dryer belt slides off the pulley when manually rotated counter clockwise8 pg
- Service Bulletin8 pg
- SERVICE BULLETIN - Dryer belt slides off the pulley when manually rotated counter-clock wise (ccw)8 pg
MyPros+ Max
Diagnose your Samsung DV350AGW/XAA.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (11)
CodeMeaning
bEInvalid state of key circuit short for 30 seconds.dEDoor opendFInvalid state of door sensor circuit.dORunning the dryer with the door open (invalid state for more than 0.25 seconds).EEpromEEprom failEtInvalid state of EEPROM communication.FEInvalid power source frequency detected.hEInvalid heating temperature while running the dryer.odInvalid dry time in excess of expected dry time (sensor bar open or excessive…tOThe thermistor resistance is very low or high (alternate display).tSThe thermistor resistance is very low or high.Service modes (15)
- Continuous Run Mode1
- continuous_run_mode1
- Cycle Count Mode1
- Cycle Count Test Mode["During Power On state, press Temp + Signal keys for 3 seconds.","Press Signal for 3 seconds until…
- cycle_count_mode1
- Sensor Bar Touch Data Mode["Power on dryer.","Open door and press in door switch.","Start dryer tumbling.","Press Temp +…
- Software Version Mode1
- Software Version Test Mode["During Power On state, press Temp + Signal keys for 3 seconds.","Press Temp key for 3 seconds…
- software_version_mode1
- Special Test Mode (Service Mode)1
- special_test_mode1
- System Check Mode1
- System Check Mode (Special Test Mode)["With the dryer in Power Off state, press Dry Level + Power keys simultaneously.","Display will…
- system_check_mode1
- Temperature Test Diagnostic Mode["During Power On state, press Adjust Time Up + Down keys for 3 seconds.","Press Adjust Time Up to…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung dryer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax