Model reference

Sharp KB-6524PW

Name: Sharp KB-6524PW
Brand: Sharp

Microwave

1 document1 error code2 service modes

Available documentation

MyPros+ Max

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Sharp Microwave

ERROR on my Sharp KB-6524PW

M+

The AH humidity sensor has not detected

From Service Manual 923891, p.23:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

CodeMeaning

AH Sensor Control Unit Check (Dummy Resistor Test)["Disconnect power supply cord and disassemble per Microwave Drawer Disassembly page 22.","Open the…
AH Sensor Test Mode (Water Load Cooking Test)["Ensure oven has been plugged in at least two minutes before testing.","Fill approximately 200…

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass