mypros+
Error code reference

Sharp Microwave Error Code ERROR

Displayed when the AH sensor cannot detect food vapor during sensor cooking, or when the door is opened or Stop/Clear pad is touched during the first 16-second stage of sensor cooking, or when the bridge circuit cannot be balanced due to disconnection of the absolute humidity sensor.

SourceSharp R-430B Series Microwave - Service Manual (Supplemental)11-12 (Procedure L)

Sharp codesSharp microwave codes
Diagnostic procedure

The full ERROR procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Check initial sensor cooking conditions (oven plugged in at least 5 minutes, room temp below 95°F, exterior of cooking container and oven interior are dry). If conditions are met, perform AH Sensor Test (Procedure L) to determine if AH sensor or control unit is defective.

SourceSharp R-430B Series Microwave - Service Manual (Supplemental)11-12 (Procedure L)

Unlock with pass
Unlock with pass
Unlock with pass
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock ERROR procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

24 manuals in the MyPros+ library document this code for Sharp microwave.

Models covered by the manuals that document this code

More models are covered than are listed here.

Related Sharp microwave error codes

All Sharp microwave codes

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax