Model reference

Sharp KB-6025MK

Name: Sharp KB-6025MK
Brand: Sharp

Microwave

2 documents1 error code4 service modes

Available documentation

Service Manual Microwave Drawers KB-6024MS / KB-6024MK / KB-6024MW KB-6025MS / KB-6025MK / KB-6025MW44 pg
Covers this model
Service Manual - Microwave Drawer44 pg
Covers this model

MyPros+ Max

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Sharp Microwave

ERROR on my Sharp KB-6025MK

M+

Sensor cooking failure - the AH

From Service Manual 140640, p.12:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

CodeMeaning

AH Sensor Control Unit Check (Dummy Resistor Method)["Disconnect power supply cord and disassemble per Microwave Drawer Disassembly.","Open drawer and…
AH Sensor Water Load Cooking Test["Ensure oven has been plugged in at least two minutes.","Fill approximately 200 milliliters (7.2…
Defrost Test["Ensure oven is fully assembled.","Place one cup of water in center of tray in oven…
Relay Test["Disconnect power supply cord and remove outer case.","Open door and block it open.","Discharge…

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass