Model reference

Thermador SCD272

Oven

3 documents19 error codes3 service modes

Available documentation

Service Manual

Thermador SCD Oven Service64 pg
Covers this model
Care & Use Manual for Thermador Built-In Oven40 pg
Covers this model

Installation Guide

KIT INSTALLATION INSTRUCTIONS - Display Head Kit for S Ovens1 pg
Covers this model

MyPros+ Max

Diagnose your Thermador SCD272.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Thermador Oven

Err on my Thermador SCD272

M+

Flashes if invalid oven temperatures or

From Service Manual 904251, p.23:

1.Access service mode to confirm the active fault code and read stored error history.

2.Disconnect the sensor and measure resistance. Expected: 10 kΩ to 12 kΩ at 77°F (25°C).

3.Check the sensor harness for opens. A reading outside 5 kΩ to 50 kΩ indicates a failed sensor.

Part 00617955

Temperature sensor (NTC)

Error codes (19)

CodeMeaning

ErrFlashes if invalid oven temperatures or times are entered.F-Function error code indicating a system fault.F0No error codes exist (displayed when checking stored error codes in test mode…F1Element supervisor is enabled; bad main relay board.F2Over temperature detected; intermittent temperature sensor or bad main relay…F3Open temperature sensor; an open circuit in the oven sensor wiring.F4Shorted temperature sensor; a short circuit in the oven sensor wiring.F5Element supervisor is disabled (single/upper oven); intermittent single/upper…F6The control is reading a shorted key; possible bad connection to the touch…F7Shorted meat probe (the meat probe option is not used in this appliance); bad…F8Invalid door lock switch status (single/upper oven); defective or jammed…F9Communication error detected by display head.FABad analog-to-digital (A/D) converter.FbCommunication error detected by main relay board.FCInvalid door lock switch status (lower oven); defective or jammed lower oven…FdCommunication error detected by main relay board.FECommunication error detected by main relay board; bad display head.FFElement supervisor is disabled (lower oven); intermittent lower oven…FrFunction error code indicating a system fault.

Service modes (3)

24-Hour Clock / Centigrade Format Selection["Turn electric power to the oven OFF at the circuit breaker.","While touching either TIMER 1 or…
Electronic Oven Control Test Mode["Method 1
Oven Temperature Calibration["Touch Bake and then any number between 500° to 550°F (or 260° to 290°C).","Touch and hold Bake…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Thermador oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass