Model reference

Whirlpool W11777856

Name: Whirlpool W11777856
Brand: Whirlpool

Dishwasher

1 document26 error codes1 service mode

Available documentation

Service Manual

Technical Manual - 24" Filtration Dishwasher140 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W11777856.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

F10E1 on my Whirlpool W11777856

M+

Dispenser electrical problem; loose

From Tech Sheet W11833455, p.27:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (26)

CodeMeaning

F10E1Dispenser electrical problem; loose connection in dispenser circuit and/or open…F10E2Vent electrical problem; loose connection in vent circuit and/or open vent wax…F10E3Drying fan electrical problem; loose connection in fan circuit and/or open fan…F10E4Diverter can't find positions; corroded or loose connection in diverter sensor…F10E5Diverter leak (motor); corroded or loose connection in diverter sensor circuit…F1E1Relay or TRIAC failure on the main control board.F1E2Motor control circuit (MCU) failure on the main control board.F2E1Stuck key detected by control; monitored on models with key switches only, not…F3E1Open or shorted connection or component in temperature sensing circuit…F3E2OWI calibration failure or OWI lens obstructed by hard water build up or food…F4E2Heater relay stuck open or heater element open; open connection in heater…F4E3Heater relay shorted/stuck closed or heater component shorted to ground.F5E1Door stuck open; door was not latched within 4 seconds of pressing…F5E2Door stuck closed; control programmed to not start if it suspects the door…F6E1User interface has power but cannot communicate with main control board; loose…F7E1Wash motor not running; loose connection in motor circuit and/or faulty wash…F7E2Variable speed wash motor failure; loose connection in motor circuit and/or…F8E1No water to dishwasher; water supply off, kinked fill hose, bowls capturing…F8E2Fill valve electrical problem; loose connection in fill valve circuit and/or…F8E3Suds/air in pump; too many suds, bowls capturing wash water, water leaking from…F8E4Overfill switch open; damaged harness, overfill switch unplugged, water in drip…F8E5Fill valve stuck open; control detects water flowing through flow meter when…F8E6Flow meter disconnected or damaged; control defaults to timed fill if flow…F9E1Not draining; drain motor electrical problem, wash motor problem, clogged…F9E2Drain motor electrical problem; loose connection in drain motor circuit and/or…F9E4Tub light circuit problem; loose connection or open circuit in tub light…

Service modes (1)

Service Diagnostics Mode["Ensure dishwasher is in standby mode.","Press any keys (except Delay, Start or Cancel) in the…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass