mypros+
Model reference

Whirlpool CEE2790K

Dryer

2 documents5 error codes19 service modes

Available documentation

Service Manual

  • Instruction Sheet - Basic Operation of Commercial Dryer6 pg
    Covers this model
  • Advantech Commercial Laundry Products178 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool CEE2790K.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (5)

CodeMeaning
88888LED test mode is active; all LEDs are lit and all display segments are…InMachine has been placed back into service after being in the out-of-service…LPLid switch fault display code shown during the service routine reset procedure…OFFMachine is out of service; can be caused by manual out-of-service setting, lid…OutMachine has been manually placed out of service by the service person.

Service modes (19)

  • Access Mode["Option A (with Palm handheld)
  • Access Mode (Freestanding Dryers Without Metercase)["1
  • Access Mode (Full Console Models)["1
  • Access Mode (Metercase Washers)["1
  • Access Mode (Stack Dryers)["1
  • Firmware Version Check["1
  • Free Vend (Run Without Payment - Dryers)["1
  • Free Vend (Run Without Payment - Washer)["1
  • LED Test Routine["1
  • Lid Switch Fault Reset (Washer)["1
  • Manual Out of Service["1
  • Manual Out of Service (OFF)["Perform all steps under Access Mode.","Push and release keypad position 5 (OFF)
  • Owner Settings["1. Perform all steps under Access Mode.","2. Push and release keypad position 1 (HOT/HIGH).","3…
  • Push-To-Start Mode["Change owner setting 'StArt' to value range 1 to activate push-to-start.","To activate a cycle…
  • Read Life Time Cycle Count["Perform all steps under Access Mode.","Life Time Cycle Count is displayed for about one minute…
  • Running Machine Without Coin Slide, Coin Drop or Smart Card["Perform all steps under Access Mode.","Push and release keypad position 3 (LOW).","Dryer is now…
  • Service Routine["Perform all steps under Access Mode.","Push and release keypad position 2 (MEDIUM). MEDIUM LED…
  • Service Routine (Dryers)["1. Perform all steps under Access Mode.","2. Push and release keypad position 2 (MEDIUM). MEDIUM…
  • Service Routine (Washer)["1. Perform all steps under Access Mode.","2. Push and release keypad position 2 (WARM). The WARM…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax