Model reference
Whirlpool W10323414A
Dryer
1 document14 error codes3 service modes
Available documentation
Service Manual
- Service Technician Manual - Dryer Diagnostic Guide16 pg
MyPros+ Max
Diagnose your Whirlpool W10323414A.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (14)
CodeMeaning
AFRestricted air flow condition exists.F:01Primary control failure.F:02Stuck button or user interface mismatch (only appears in diagnostic test mode).F:22Exhaust thermistor is open.F:23Exhaust thermistor has shorted.F:24Inlet thermistor is open (only appears in diagnostic test mode).F:25Inlet thermistor is shorted (only appears in diagnostic test mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (only appears in diagnostic test mode).F:29Moisture sensor strip has shorted (only appears in diagnostic test mode).F:30Restricted air flow condition (only appears in diagnostic test mode).F:50Water valve failureL2Low or no line voltage detected (less than 50V) at installation.PFPower failure occurred while the dryer was running.Service modes (3)
- Customer-Focused Drying Mode Adjustment1. With dryer in standby mode, press and hold the Dryness Level button for 5 seconds. Dryer beeps…
- Diagnostic Test Mode1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
- Manual Load Test1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only Done indicator…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool dryer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass