Model reference
Whirlpool WGD5010LW2
Dryer
2 documents5 error codes5 service modes
Available documentation
Service Manual
- For Service Technician's Use Only136 pg
Tech Tip
- Instruction Sheet - W11581424 - Rev A - Gas Conversion Kit6 pg
MyPros+ Max
Diagnose your Whirlpool WGD5010LW2.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (5)
CodeMeaning
F1E1Indicates an ACU (Appliance Control Unit) problem.F2E1Indicates a stuck button on the HMI (depressed for over 20 seconds).F3E1Indicates that the exhaust thermistor is open or shorted; open if temperature…F3E2Indicates the moisture sensor strip is open or shorted; this fault code will…F6E1Communication between the ACU and HMI has not been detected.Service modes (5)
- Button Activation & Encoder Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…
- Fault Code Display / Clear["Activate Service Diagnostic Mode first.","Press and release the 3rd button used to activate…
- Service Diagnostic Mode["Ensure dryer is in standby mode (plugged in with all LEDs off).","Select any three (3) buttons…
- Service Test Mode["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
- Software Version Display["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool dryer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass