Model reference

Whirlpool WGD9270XL1

Dryer

8 documents15 error codes3 service modes

Available documentation

Tech Sheet

Tech Sheet - W10294025 - Rev B16 pg
Covers this model
Tech Sheet whirlpool duet dryer W10443109 Rev A64 pg
Covers this model

Service Flash

Horizon Next Generation Steam Dryers Filling with Water1 pg
Covers this model

Tech Tip

Instruction Sheet3 pg
Covers this model
Instruction Sheet - W10318609- Rev A - Special Handling7 pg
Covers this model
Instruction Sheet2 pg
Covers this model

Installation Guide

Instrucciones de instalacion16 pg
Covers this model
Installation Instructions32 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WGD9270XL1.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dryer

f1 e1 on my Whirlpool WGD9270XL1

M+

Primary control failure.

From Tech Sheet W17229495, p.27:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (15)

CodeMeaning

f1 e1Primary control failure.F1E1Primary control failure.f2 e1Stuck button or user interface mismatch (only appears in service diagnostic…F2E1Stuck button or user interface mismatch f3 e1Exhaust thermistor is open.f3 e2Exhaust thermistor has shorted.f3 e6Moisture sensor strip is open (only appears in service diagnostic mode).f3 e7Moisture sensor strip has shorted (only appears in service diagnostic mode).F3E1Exhaust thermistor is open.F3E2Exhaust thermistor has shorted.F3E6Moisture sensor strip is open F3E7Moisture sensor strip has shorted f8 e1No voltage detected at the water valve relay (steam models only, only appears…F8E1No voltage is detected at the water valve relay pfPower failure occurred while the dryer was running.

Service modes (3)

Customer-Focused Drying Mode Adjustment["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the DONE…
Service Diagnostic Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the DONE…
User Interface/Control System Test["First activate the Service Diagnostic mode.","Press and release the 1st button used to enter…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass