mypros+
Model reference

Whirlpool YMED7230HC2

Dryer

5 documents11 error codes14 service modes

Available documentation

Tech Sheet

  • Service Guide - Tech Sheet W1117522244 pg
    Covers this model

Service Manual

  • Technical Manual - Whirlpool® and Maytag® Dryer61 pg
    Covers this model
  • Service Manual Whirlpool & Maytag 27" Front-load Gas & Electric Dryers80 pg
    Covers this model

Service Flash

  • 27" Dryer Top Panel Design Change Control Bracket Eliminated9 pg
    Covers this model

Quick Reference

  • Quick Start Guide24 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool YMED7230HC2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (11)

CodeMeaning
F1E1No voltage detected at the heater relay or main control (ACU) problem.F2E1Indicates a stuck button (depressed for over 20 seconds)F2E2The HMI has detected an internal fault (HMI Disconnected).F3E1Exhaust thermistor is open or shortedF3E2Moisture sensor strip is open or shorted.F3E3Inlet thermistor is open or shortedF3E5Rear moisture sensor strip is open or shorted.F6E1Communication between the HMI and ACU has not been detected.F6E2WiFi Module has not responded for a specified amount of time.FCE1WiFi Module communications lost.PFPower failure occurred while the dryer was running.

Service modes (14)

  • Component Activation / Quick Service Cycle (LCD in Door Models)["Enter Service Diagnostic Mode (LCD in Door) first.","From the DIAGNOSTICS HOME screen, scroll…
  • Diagnostic CycleEnter Service Mode, navigate to Service Diagnostics, then select Diagnostic Cycle
  • Diagnostic Cycle (Factory)["Enter Service Mode.","Navigate to Factory Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Diagnostic Cycle (Service Diagnostics)["Enter Service Mode.","Navigate to Service Diagnostics.","Navigate to Diagnostic Cycle and select…
  • Diagnostic Cycle (Service)["Enter Service Mode.","Navigate to Service Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Factory Reset["Enter Service Mode.","Navigate to Factory Diagnostics.","Select Factory Reset."]
  • HMI Test["Enter Service Mode.","Navigate to Service Diagnostics.","Navigate to HMI Test and select…
  • Key Activation & Encoder Test (Console Models)["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…
  • Sensor Feedback["Enter Service Mode.","Navigate to Service Diagnostics.","Navigate to Sensor Feedback and select…
  • Service Diagnostic Mode (Console Models)["Ensure the dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…
  • Service Diagnostic Mode (LCD in Door Models)["Ensure the dryer is in standby mode (plugged in with all indicators off).","Open and close the…
  • Service Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…
  • Service Test Mode (Console Models)["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Software Version Display (Console Models)["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass