Model reference
Whirlpool YWED9400SZ0
Dryer
5 documents20 error codes6 service modes
Available documentation
Tech Sheet
- Tech Sheet W1011064016 pg
- Whirlpool Dryer YWED9200SQ0 Tech Sheet16 pg
Tech Tip
- Instruction Sheet - 8574875 - Rev A - Special Handling4 pg
- Instruction Sheet2 pg
- Instruction Sheet12 pg
MyPros+ Max
Diagnose your Whirlpool YWED9400SZ0.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (20)
CodeMeaning
F:01Primary control failure.F:02Stuck button or user interface mismatch; this fault code will ONLY appear when…F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open; this fault code will ONLY appear when in the…F:25Inlet thermistor has shorted; this fault code will ONLY appear when in the…F:26Motor drive system failure.F:28Moisture sensor strip is open; this fault code will ONLY appear when in the…F:29Moisture sensor strip has shorted; this fault code will ONLY appear when in the…F:30Restricted airflow condition exists; this fault code will ONLY appear when in…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).PFPower failure occurred while the dryer was running.Service modes (6)
- Adjusting Customer-Focused Drying Modes (CF1/CF2/CF3)1
- Displaying Inlet Air Flow["Activate diagnostic test mode and advance past all saved fault codes.","Press the Wrinkle Shield…
- Displaying Line Voltage["Activate diagnostic test mode and advance past all saved fault codes.","Press the Cycle Signal…
- Manual Load Test1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
- Manual Load Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
- Service Diagnostic Test Mode1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool dryer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass