Model reference

Whirlpool GBD307PDT6

Oven

7 documents30 error codes5 service modes

Available documentation

Tech Sheet

Tech Sheet - do not Discard12 pg
Covers this model
TECH SHEET6 pg
Covers this model
Whirlpool Range RBD275PDQ8 Tech Sheet1 pg
Covers this model
Tech Sheet - 44518876 pg
Covers this model
TECH SHEET - Whirlpool Oven RBD305PDB96 pg
Covers this model

Service Manual

Electric Built-In Double Oven KR-3059 pg
Covers this model

Installation Guide

Installation Instructions5 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool GBD307PDT6.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Oven

F0 on my Whirlpool GBD307PDT6

M+

Default F code - no failure.

From Tech Sheet W13810181, p.33:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (30)

CodeMeaning

F0Default F code F1Electronic control malfunction (all E codes under F1).F1-E0Key held down too long, or key is shorted.F1-E1Keypad keytail not connected.F1-E2Key held down too long, or key is shorted.F1-E5CANCEL key drive line open.F1-E6CANCEL key drive line open.F2Oven temperature is too high (oven overheated).F2-E0Temperature sensor opened.F2-E1Temperature sensor shorted.F2-E2Oven temp too high F2-E3Oven temp too high F3Oven temperature sensor is open (open circuit in sensor).F3-E0Door is open but latch is locked (door switch closed indicating open door and…F3-E1Self-clean latch will not lock.F3-E3Oven temp too high F3-E5Self-clean temperature 288°C (550°F) not reached within 45 minutes.F3-E7Self-clean latch will not unlock.F4Oven temperature sensor is shorted (short circuit in sensor).F4-E0Meat probe malfunction F4-E1Oven temp too high F5Control board relay failure.F5-E0Door is open but latch is locked (condition exists when door switch is closed…F5-E1Self-clean latch will not lock.F5-E5Self-clean temperature 288°C (550°F) not reached within 45 minutes.F5-E7Self-clean latch will not unlock.F6Return line not connected F6-E0Switch pulse return line not connected.F7Door latch switch or motor failure during self-clean cycle.F8Electronic control board configuration error.

Service modes (5)

Bake Temperature Offset Adjustment1
Cavity Size ProgrammingWithin 60 seconds of power up, press the following touchpads in order
Fahrenheit to Celsius ConversionPress the BROIL pad for 5 seconds
Fault Code Display (No Pre-existing Fault)["Press and hold UPPER OFF key for 5 seconds
Programming the Cavity Size1. Within 60 seconds of power up, press the following touchpads

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass