mypros+
Model reference

Whirlpool 4GWTW5550YW2

Washer

2 documents21 error codes8 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10547603 - Rev A20 pg
    Covers this model

Tech Tip

  • product-inserts-W10623835-RevD.pdf4 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool 4GWTW5550YW2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (21)

CodeMeaning
F0E2Over suds condition detectedF0E4High water temperature during rinse cycleF0E5Off balance load detected during operation.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Mismatch of Main Control and UIF3E1Pressure sensor faultF3E2Inlet water temperature faultF5E1Lid switch fault (lid up)F5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill / long fillF8E3Overflow conditionF8E5Hot and cold water supply hoses are reversed.F9E1Long drain

Service modes (8)

  • Automatic Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Spin LED is On (display…
  • Calibration Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse LED is On (display…
  • Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Done LED is On (display…
  • Manual Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Spin and Done LEDs are On…
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
  • Software Version Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse, Spin, and Done LEDs…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Wash and Done LEDs are On…
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse and Spin LEDs are On…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax