mypros+
Model reference

Whirlpool 7MWFW5622HW0

Washer

7 documents29 error codes5 service modes

Available documentation

Tech Sheet

  • Whirlpool Control Panel Service Technical Sheet28 pg
    Covers this model
  • Tech Sheet - W11417642 - Rev G2 pg
    Covers this model
  • Service Technician Technical Sheet W11417642E2 pg
    Covers this model

Service Manual

  • Service Manual Whirlpool & Maytag 27" Front-load Washers94 pg
    Covers this model

Service Flash

  • Service Pointer - W11401418 - Rev C - 27 Front Load Washer Long Cycle6 pg
    Covers this model

Quick Reference

  • Quick Reference Manual1 pg
    Covers this model

Other

  • Service Pointer - W11375982 - ACU Diagnostic LED Correction_W113759823 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool 7MWFW5622HW0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (29)

CodeMeaning
F0E1Load detected in drum during Clean Washer cycle.F0E2Oversuds condition detected.F0E4High temperature error during wash cycle.F0E5Off balance load detected.F1E1Main relay open or shorted.F1E2MCU over-voltage or under-voltage error.F3E1Wash NTC open or shorted.F3E2Wash NTC (thermistor) open or shorted.F3E5Dry NTC fault.F3E6Accelerometer error.F4E1Wash heater relay error or no feedback signal.F4E2Wash heater relay error.F4E4Blower error.F5E2Door lock failure.F5E3Door unlock failure.F5E4Door not open error.F6E1No communication from the HMI detected by ACU.F6E2No communication from the ACU detected by the HMI.F6E3No communication from the MCU detected by the ACU.F7E10Motor disconnected error (also displayed as F7EA).F7E12MC/MCU overload (also displayed as F7EC).F7E2MC/MCU over temperature error.F7E8MC/Motor over temperature error.F7E9Motor will not turn (locked rotor).F7EAMotor disconnected error (alternate hex display of F7E10).F7ECMC/MCU overload (alternate hex display of F7E12).F8E1Long fill condition (also displayed as Lo Flo).F8E3Overflow condition detected.F9E1Long drain condition.

Service modes (5)

  • Fault/Error Code Display["Enter Service Diagnostic Mode
  • Human-Machine Interface Test["First activate Service Diagnostic Mode.","Press and release the 1st button used to activate…
  • Quick Diagnostic Test["First activate Service Diagnostic Mode.","Press and release the 2nd button used to activate…
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","After initial power is…
  • Software Version Display["First activate Service Diagnostic Mode.","Press and hold the 2nd button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax