mypros+
Model reference

Whirlpool CAE2792K

Washer

3 documents5 error codes18 service modes

Available documentation

Service Manual

  • Instruction Sheet - Basic Operation of Commercial Washer Model CAE2792K8 pg
    Covers this model
  • Advantech Commercial Laundry Products178 pg
    Covers this model

Other

  • 81781504 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool CAE2792K.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (5)

CodeMeaning
88888LED test mode is active; all LEDs are lit and all display segments are…InMachine has been placed back into service after being in the out-of-service…LPLid switch fault display code shown during the service routine reset procedure…OFFMachine is out of service. Can be caused byOutMachine has been manually placed out of service by the service person.

Service modes (18)

  • Access Mode (Freestanding Dryers Without Metercase)["1
  • Access Mode (Full Console Models)["1
  • Access Mode (Metercase Washers)["1
  • Access Mode (Stack Dryers)["1
  • Access Mode (via Palm handheld)["Use Service Routine software on Palm handheld.","Hold the handheld at a 90° angle no more than…
  • Access Mode (without Palm handheld)["Open the console to gain access to the electronic control.","Push and release the small push…
  • Firmware Version Check["1
  • Free Vend (Run Without Payment - Dryers)["1
  • Free Vend (Run Without Payment - Washer)["1
  • LED Test Routine["Perform all steps under ACCESS MODE.","Push and release keypad position 5 (GENTLE).","All LEDs…
  • Lid Switch Fault Reset (Washer)["1
  • Manual Out of Service["1
  • Manual Out of Service (OFF)["Perform all steps under ACCESS MODE.","Push and release keypad position 5 (GENTLE)
  • Owner Settings["Perform all steps under ACCESS MODE.","Push and release keypad position 1 (HOT).","Keypads are…
  • Running Machine Without a Smart Card["Perform all steps under ACCESS MODE.","Push and release keypad position 3 (COLD).","Washer is now…
  • Service Routine["Perform all steps under ACCESS MODE.","Push and release keypad position 2 (WARM). WARM LED starts…
  • Service Routine (Dryers)["1. Perform all steps under Access Mode.","2. Push and release keypad position 2 (MEDIUM). MEDIUM…
  • Service Routine (Washer)["1. Perform all steps under Access Mode.","2. Push and release keypad position 2 (WARM). The WARM…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax