mypros+
Model reference

Whirlpool CAP2761

Washer

8 documents5 error codes23 service modes

Available documentation

Service Manual

  • Washer Dryer Service Document84 pg
    Covers this model
  • EMS 1000 Commercial Laundry Products84 pg
    Covers this model
  • Advantech Commercial Laundry Products178 pg
    Covers this model

Service Flash

  • Service Pointer - Washer will not Fill4 pg
    Covers this model
  • EMS 1000 Electronic-Controlled Washers Will Not Fill4 pg
    Covers this model
  • Service Pointer - 8178388 - Blank Display1 pg
    Covers this model
  • Commercial Washers/Dryers Service Pointer1 pg
    Covers this model

Other

  • advantech cae2761k178 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool CAP2761.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (5)

CodeMeaning
88888LED test mode is active; all LEDs are lit and all display segments are…InMachine has been placed back into service after being in the out-of-service…LPLid switch fault display code shown during the service routine reset procedure…OFFMachine is out of service; can be caused by manual out-of-service setting, lid…OutMachine has been manually placed out of service by the service person.

Service modes (23)

  • Access Mode (Freestanding Dryers Without Metercase)["1
  • Access Mode (Full Console Models)["1
  • Access Mode (Metercase Washers)["1
  • Access Mode (Stack Dryers)["1
  • Dryer Access Mode / Service Routine["Remove the access door on the top of the meter case.","Push the rocker switch just inside the…
  • Dryer LED Test Routine["Perform all steps under Access Mode.","Push and release keypad position S5
  • Dryer Run Without Coin Slide["Perform all steps under Access Mode.","Push and release keypad position S3.","Push START keypad S4
  • Dryer Set Run Time["Perform all steps under Access Mode.","Push and release keypad position S4
  • Dryer Set Vend Price["Perform all steps under Access Mode.","Push and release keypad position S1
  • Firmware Version Check["1
  • Free Vend (Run Without Payment - Dryers)["1
  • Free Vend (Run Without Payment - Washer)["1
  • LED Test Routine["1
  • Lid Switch Fault Reset (Washer)["1
  • Manual Out of Service["1
  • Owner Settings["1. Perform all steps under Access Mode.","2. Push and release keypad position 1 (HOT/HIGH).","3…
  • Service Routine (Dryers)["1. Perform all steps under Access Mode.","2. Push and release keypad position 2 (MEDIUM). MEDIUM…
  • Service Routine (Washer)["1. Perform all steps under Access Mode.","2. Push and release keypad position 2 (WARM). The WARM…
  • Washer Access Mode / Service Routine["Remove the access door on the top of the meter case.","Push the rocker switch just inside the…
  • Washer Diagnostic Test Routine (Component Activation)["Open the access lid in the meter case.","Push the momentary service switch found just inside the…
  • Washer LED Test Routine["Perform all steps under Access Mode.","Push and release keypad position S5
  • Washer Run Without Coin Slide["Perform all steps under Access Mode.","Push and release keypad position S3
  • Washer Set Vend Price["Perform all steps under Access Mode.","Push and release keypad position S1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax