mypros+
Model reference

Whirlpool W10338674

Washer

1 document22 error codes8 service modes

Available documentation

Tech Sheet

  • Kenmore Whirlpool Washer 110 28002011 Tech Sheet44 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10338674.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
F0E0No fault codes stored.F0E2Over suds condition detected; suds prevent basket from spinning up to speed or…F0E4High water temperature detected (105°F or higher) during rinse cycle.F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control fault on the main control board.F2E1Stuck keyF2E3Mismatch of main control and UIF3E1Pressure sensor faultF3E2Inlet water temperature faultF5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill, long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drain

Service modes (8)

  • Automatic Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Spin' LED is On (display…
  • Calibration Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Rinse' LED is On (display…
  • Fault Code Display Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Done' LED is On (display…
  • Manual Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Spin & Done' LEDs are On…
  • Service Diagnostic Test Mode Entry["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
  • Software Version Display Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Rinse, Spin, and Done' LEDs…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Wash and Done' LEDs are On…
  • UI Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Rinse & Spin' LEDs are On…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass