mypros+
Error code reference

Ariston Washer Error Code DOOR

Warning signalled if user does not close the door within 20 seconds of pressing start; washing machine does not start the cycle.

Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the DOOR error code actually means

Your Ariston washer is telling you that the door was not fully closed within 20 seconds of pressing the start button, so it stopped the cycle from beginning. Simply close the door firmly until you hear it click, and the warning will go away. If the warning keeps showing up even after closing the door, there may be a problem with the door latch that needs attention.

Diagnostic procedure

The full DOOR procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Close the door, the warning disappears and the cycle starts.
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock DOOR procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of DOOR

Ranked by how often they cause this code
  1. 1Door not fully closed before or after pressing start
  2. 2Worn or damaged door latch and strike
  3. 3Faulty door interlock switch
  4. 4Obstruction preventing full door closure
  5. 5Damaged door wiring harness

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about DOOR

What does DOOR mean on a Ariston washer?
The DOOR warning means the washer detected that the door was not fully closed and latched within 20 seconds of pressing the start button. As a safety measure, the machine will not begin the wash cycle until the door interlock is properly engaged. This is a protective feature to prevent water entry and drum movement with an unsecured door. In most cases, simply closing the door firmly resolves the warning immediately.
Is it safe to use my Ariston washer when the DOOR warning is showing?
The washer will not start or operate while the DOOR warning is active, so there is no immediate safety risk. The warning is a built-in safeguard that prevents the machine from running with an unsecured door. Do not attempt to bypass or force the door interlock, as the interlock exists to prevent water leaks and injury during drum operation.
How much does it cost to repair an Ariston washer showing the DOOR warning?
If the issue is just an unlatched door, there is no cost involved. If the door latch assembly or interlock switch needs replacement, parts typically range from around $15 to $60 depending on the specific component, with labor costs adding $50 to $150 if a technician performs the repair. A damaged wiring harness repair may fall at the higher end of that labor range due to the additional diagnostic time involved.
How do I fix the DOOR warning on my Ariston washer?
Start by firmly pushing the door closed until you hear or feel the latch click into place, then check whether the warning clears. Also inspect the door opening for any clothing or debris caught in the seal that could be preventing full closure. If the warning persists after confirming the door is shut, the door latch assembly or interlock switch may need to be inspected and potentially replaced.
Will resetting my Ariston washer clear the DOOR warning?
Resetting the machine by turning it off and back on will not clear the DOOR warning if the underlying cause is still present. The warning will reappear as soon as start is pressed again if the door is not properly latched or if a faulty component is preventing the interlock signal from reaching the control board. The root cause must be addressed first, whether that is simply closing the door or repairing a worn latch or switch.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass