Bosch Dryer Error Code E:24

E:24 means the dryer's control module is running a software version that does not match the internal configuration table the dryer uses for validation. When this mismatch is detected, the dryer stops immediately and cannot be restarted. This is a hard electronic fault that requires control module replacement to resolve.

No. A power cycle or reset does not alter the software version stored on the control module, so the mismatch will still be detected when the dryer powers back on. The E:24 fault will persist and the dryer will continue to refuse to start until the control module is replaced.

The cost depends on whether you hire a technician or replace the control module yourself. Control module parts for Bosch dryers typically range from $80 to $250 depending on the model. With professional labor, total repair costs generally fall in the range of $150 to $400. Getting a firm estimate before authorizing the repair is advisable.

The fix requires replacing the control module with one that carries the correct software version for your specific dryer model. This is a task some experienced DIYers can perform, as it typically involves disconnecting the wiring harness and mounting the new module. However, sourcing the correct module is critical, since installing an incompatible unit will reproduce the same error.

The dryer will not operate at all when E:24 is active, so there is no immediate safety risk from the fault itself. The lockout is intentional and prevents the dryer from running in a misconfigured state. Do not attempt to bypass or force-start the dryer while this fault is present.