mypros+
Model reference

Bosch WTMC6500UC/01

Dryer

3 documents14 error codes13 service modes

Available documentation

Service Manual

  • WTMC Gas & Electric Dryer Training Manual68 pg
    Covers this model
  • Wtmc/wtxd Gas & Electric Dryer Training Manual76 pg
    Covers this model

Training

  • Nexxt Dryer Training/Repair Manual31 pg
    Covers this model
MyPros+ Max

Diagnose your Bosch WTMC6500UC/01.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (14)

CodeMeaning
E:01Overheating due to clogged lint filter (displayed during normal use…E:03Maximum drying time exceeded, displayed during normal use after 240-minute…E:11Overheating due to clogged lint filter; measures reduced air flow.E:12Severe overheating due to clogged lint filter; measures reduced air flow.E:13Maximum drying time exceeded (240 minutes); usually a faulty heater or…E:17NTC error for NTC R3 at lint screen; typically a shorted or opened wire harness.E:18NTC error for NTC R2 at heater; typically a shorted or opened wire harness.E:20EEPROM error; dryer stops and cannot be restarted.E:21Incorrect checksum; dryer stops and cannot be restarted.E:22Invalid update; dryer stops and cannot be restarted.E:23Model variant doesn't match table; dryer stops and cannot be restarted.E:24Software version doesn't match table; dryer stops and cannot be restarted.E:25Damaged data table; dryer stops and cannot be restarted.E:26Control error.

Service modes (13)

  • 240V to 208V Voltage Changeover["Enter test program.","Rotate cycle selector knob to 60 minute Time Dry (WTMC33/WTXD53) or Medium…
  • 240V/208V Voltage Changeover["Enter test program.","Rotate cycle selector knob to 8th position on right (cw)
  • Consumer Test (Amp Draw Test)["Disconnect electric power and remove rear cover, ensuring no electrical shorts or shock…
  • Control Elements Test["Enter test program.","Rotate cycle selector knob to Damp Dry
  • Display Test (LEDs/LCDs)["Enter test program.","Rotate cycle selector knob to Regular Dry
  • Moisture Sensor Conductance Test["Disconnect electric power. Remove rear cover. If necessary, remove drum for access to moisture…
  • Moisture Sensor Resistance Measurement["Enter test program.","Rotate cycle selector knob to 6th position on right (cw)
  • Safety Test["Enter test program.","Rotate cycle selector knob to 2nd position on right (cw)
  • Sales Demo Mode["Push and hold Start/Stop and Delicates buttons.","Rotate cycle selector knob to 40 minute Timed…
  • Sales Demo Mode (Alternative Entry)["Push and hold Start/Stop and Delicates buttons.","Rotate cycle selector knob to 40 minute Timed…
  • Sales Demo Program["Enter test program.","Rotate cycle selector knob to 7th position on right (cw)
  • Test Program (Diagnostic Mode)["Rotate cycle selector knob to Off position.","Push and hold Start/Stop and Delicates buttons at…
  • View Fault Codes["Enter test program (hold Start/Stop and Delicates, rotate knob on).","Rotate cycle selector knob…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Bosch dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass