Skip to main content
Error code reference
Dacor Dishwasher Error Codes
16 error codes documented with diagnostic procedures.
Have your model number? Get codes specific to your unit.
CFClean Filter-the filters need to be removed and cleanedCLClose the door-a wash or rinse cycle has been started or is in process and the door needs…DrainPressure switch is in the closed position after two full drain procedures, indicating…F-1Inlet valve fault-after the fill cycle, if the WPS does not detect conductivity (presence…F-2Circulation pump/drying fan fault-the controller looks for relay closure on the power…F-3Electrical/heater fault-during wash and rinse cycles the WPS monitors water temperature…F-4Drain pump fault-following a drain cycle, if the WPS still detects water conductivity in…F-6Controller/Floor Guard fault.F-7EEPROM failure.F-8Communication failure-error in data transfer between the control board (master micro) and…F5Controller failure to communicate with PIC or no PIC software in the power board PIC…F9Heater failure; temperature does not increase.HOHot-the water is heating in preparation for Hi-Temp or Sanitize operations.LORinse aid level is low-the rinse aid dispenser needs to be refilled.PFPower Fail-power to the appliance has been interrupted; also appears when the dishwasher…Water in Base PanFloor guard switch has opened due to a flood condition detected in the base pan area.
Get the full diagnostic procedure for any code
Step-by-step tests, expected values, wiring diagram references, and verified part numbers.
Get Started $9.95 3-day pass$29/month for all brands and Max diagnostics, with 70 Max messages a day. Plus applicable tax.