Electrolux Dishwasher Error Code F7

The F7 code means the dishwasher detected a pumping out fault. On models with a pressure sensor, the machine was unable to evacuate water from the tub within 120 seconds of the drain pump running. The programme is interrupted and the fault is logged to prevent the cycle from continuing with standing water present.

Resetting the machine may clear the displayed code temporarily, but the F7 fault will return if the underlying drainage problem has not been resolved. A reset is useful for confirming whether the issue was a one-time event, such as a partial blockage, but it is not a fix on its own. Address the root cause before relying on a reset.

Repair costs vary depending on the cause. Clearing a blocked filter or repositioning a kinked hose costs nothing beyond your time. Replacing a drain pump typically runs between $80 and $200 including the part and labor, depending on your location and service provider. A faulty control unit is generally the most expensive component to replace, often ranging from $150 to $350 or more for parts and labor.

Many F7 faults can be resolved without professional help. Start by cleaning the drain filter and pump housing at the bottom of the tub, then check the drain hose for kinks or blockages, and verify the sink drain connection is clear. If the error persists after clearing these areas, the fault may involve the drain pump motor, pressure sensor, or control board wiring, which are more involved repairs.

You should not continue using the dishwasher while F7 is active. The programme interrupts specifically because water has not drained as expected, and running further cycles risks water remaining in the tub, potential leaks, or damage to other components. Resolve the drainage fault before resuming normal use.