Electrolux Dishwasher Error Code CE

CE stands for Configuration Error on an Electrolux dishwasher. It means the control board detected a problem with its stored options or settings data during its power-up self-check. The dishwasher will not operate normally until the configuration issue is resolved. This fault is almost always related to the control board's internal memory rather than an external component.

The dishwasher will not proceed through a normal wash cycle while the CE error is active, so there is no immediate safety hazard from the code itself. However, you should not attempt to bypass or ignore the error and force a cycle to run. It is best to diagnose and resolve the issue before using the appliance again.

If the fix is simply a power reset, there is no parts cost involved. If the main control board needs to be replaced, parts and labor costs typically range from around 150 to 400 dollars depending on the specific model and local labor rates. Getting a professional diagnosis first is worthwhile to confirm the control board is actually the failed component before purchasing parts.

A hard reset, done by disconnecting power for several minutes, can sometimes clear a CE error if it was caused by a temporary glitch or minor memory issue. However, if the error returns immediately after the reset, the control board's memory is likely corrupted or the board itself is faulty. In that case, a simple reset will not provide a lasting fix.

Start by disconnecting the dishwasher from power for at least five minutes to allow a full reset of the control board. If the CE error returns after restoring power, the control board likely has corrupted memory or a hardware fault and will need to be replaced. If a control board was recently swapped out, confirm that the replacement board is the correct part for your specific model.