Electrolux Dishwasher Error Code E1

E1 on an Electrolux dishwasher means the appliance did not receive enough water within the expected fill time. The control board monitors how long it takes for the tub to reach the required water level, and E1 is triggered when that time limit is exceeded. This points to a restriction or failure somewhere in the water supply or inlet system.

Resetting the dishwasher by canceling the cycle or cutting power may temporarily clear the E1 display, but the error will return at the next fill attempt if the underlying cause has not been resolved. A reset is useful for confirming whether the problem is intermittent or persistent, but it is not a fix on its own.

If the cause is simply a closed valve or kinked hose, there is no parts cost involved. Replacing a clogged or failed water inlet valve typically costs between $25 and $90 for the part, with additional labor costs if a technician is hired. A water level pressure switch replacement generally falls in a similar range, though total repair costs vary based on your location and service provider.

Start by confirming the water supply shutoff valve under the sink is fully open and that household water pressure is normal. Next, inspect the inlet hose for kinks and check the inlet valve screen for sediment buildup, cleaning it if necessary. If the supply side checks out, the inlet solenoid valve or water level pressure switch may need to be tested and replaced.

The dishwasher will not complete a wash cycle while E1 is active because it has already stopped the fill sequence as a protective measure. Attempting to run the appliance repeatedly without addressing the cause is not recommended, as it will not function normally and continued attempts will not resolve the fault.