Electrolux Dishwasher Error Code LD10 flashing

LD10 flashing indicates a discharge pump error where the pressostat has not reached its return point after two pumping cycles. In practical terms, the dishwasher attempted to drain water twice and the pressure switch never confirmed that the tub reached an empty state. This typically points to a blocked drain pump, clogged filter, obstructed drain hose, or a fault with the pressostat itself. The machine stops the program and alerts you rather than continuing to cycle with standing water.

No, you should not attempt to continue running a full wash cycle while LD10 is active. The error means the dishwasher could not confirm proper drainage, so there may be standing water in the tub. Running additional cycles without resolving the drainage issue risks overflow, potential water damage, and further stress on the pump motor. Resolve the drain blockage before restarting the appliance.

If the cause is a simple blockage in the filter or drain hose, the repair can be done at no parts cost with only your time. If the drain pump has failed and needs replacement, parts typically range from $40 to $120 depending on the model, plus labor if a technician is involved, which can add $80 to $200. A faulty pressostat is generally a lower-cost part, often in the $20 to $60 range. Getting a professional diagnosis first can help avoid replacing parts unnecessarily.

Start by checking the drain pump filter and pump area for debris such as food particles or broken glass, and clear any blockages you find. Next, inspect the full length of the drain hose for kinks or obstructions, and verify that the household drain connection or garbage disposal is not blocked. Once you have cleared any blockages, press the ON/OFF key S0 to allow the program to continue. If the error returns after clearing blockages, the drain pump or pressostat may need to be tested and replaced.

Pressing the ON/OFF key S0 is the designated step to resume the program after addressing the underlying drain issue, but simply resetting the machine without fixing the blockage will not permanently clear the code. If the drain pump or drain path is still obstructed on the next cycle, the LD10 error will return after two more failed pumping attempts. Address the root cause first, then use the S0 key to restart.