Error code reference

Fisher & Paykel Range Error Code F0-00

Temperature sensor measurement error during self-clean cycle, possibly due to the cycle being stopped and started mid-way.

SourceFisher & Paykel Freestanding Ranges - Full Service Manual (OR24/OR36/OR48)p. 82

Fisher & Paykel codes Fisher & Paykel range codes

Diagnostic procedure

The full F0-00 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

Turn the oven selector to OFF, wait at least 15 minutes before repeating the self-clean operation cycle. If message persists, check door lock, Relay 1, Relay 3, safety thermostat, broil/bottom element, mode selector contacts, or safety thermal overload.

SourceFisher & Paykel Freestanding Ranges - Full Service Manual (OR24/OR36/OR48)p. 82

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock F0-00 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

1 manual in the MyPros+ library documents this code for Fisher & Paykel range.

Models covered by the manuals that document this code

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full F0-00 procedure

Where this code is documented

Models covered by the manuals that document this code

Related Fisher & Paykel range error codes