Fisher & Paykel Range Error Codes

5 error codes for Fisher & Paykel range models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

30 F0Temperature probe ST1 short-circuit or damage to temperature probe cable.30 F1Temperature probe ST1 open circuit, damage to cable, or poorly fitted connector.DoLoDoor is locked and oven cavity temperature is above 563°F during or after…F0-00Temperature sensor measurement error during self-clean cycle, possibly due to…F2Transistor for relay one is short circuit or supply voltage is less than 150…

MyPros+ Max

Get the full diagnostic procedure for any Fisher & Paykel range error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Fisher & Paykel Range

30 F0 on my Fisher & Paykel Range

M+

Temperature probe ST1 short-circuit or damage

From Service Manual 992591, p.43:

1.Turn the oven function selector to OFF and wait for a 30 minute countdown to finish. Then check for short circuit in temperature probe ST1 or its cable, faulty connection at PCB, or faulty PCB.

2.Measure control board supply voltage at the test points. Expected: 12 VDC and 5 VDC; a drop below 4.75 VDC on the logic rail points to a failed onboard regulator.

3.Inspect all connectors on the main control for corrosion, thermal stress, or backed-out pins. Reseat each connector with the power disconnected.

Part WPW10804018

Electronic control board

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started