mypros+
Error code reference

Fisher & Paykel Oven Error Codes

19 error codes documented with diagnostic procedures.

Have your model number? Get codes specific to your unit.
30 F0Oven temperature sensor broken or not working properly during cooking or pyrolytic cycle.30 F1Oven temperature sensor broken or not working properly during cooking or pyrolytic cycle.do.LoDoor locked condition displayed during pyrolytic cycle, caused by a blackout, selector…DOORDoor is not closed or PCB cannot verify a closed position via the door lock microswitch…E001Oven cavity temperature probe in short circuit.E002Not used on these models.E004Not used on these models.E008Not used on these models.E017Overheating of oven cavity and temperature probe open circuit (combined fault value 16+1).E128Error I2C from EEPROM.ExxxCondition with more failures at the same timeFGeneral fault code indicated by the letter F followed by a number displayed in the clock…F0.00Pyrolytic cycle has been stopped and restarted when it was quite a way through; displayed…F1Maximum allowable temperature (185°F / 85°C) around the electronics was exceeded.F2Transistor for relay 1 is short circuit or supply voltage is less than 150 Volts.F3The oven temperature was sensed at over 600°F (315°C) during normal cooking operation.F4A fault occurred in the power module.F5A communications error occurred between the clock module and the power module.F7A fault occurred with the oven door lock.

Get the full diagnostic procedure for any code

Step-by-step tests, expected values, wiring diagram references, and verified part numbers.

Get Started $9.95 3-day pass

$29/month for unlimited access to all brands and Max AI diagnostics.

More Fisher & Paykel error codes

Common questions

How do I find the error code on my Fisher & Paykel Oven?
Most Fisher & Paykel ovens show the code directly on the control panel display. If your model has no display, it can be read by entering diagnostic mode with the key sequence for your model. The full procedures include model-specific instructions for reading codes.
Are these codes specific to my model?
The codes here apply broadly to Fisher & Paykel ovens. Meanings and diagnostic steps can vary by model and production year, so enter your model number for model-specific information and procedures.
What do I do if my code is not listed?
Some codes are model-specific or only appear in diagnostic mode. Enter your model number to get codes specific to your unit, or contact us. We update the database continuously from manufacturer service documentation.
How much does it cost to access the full diagnostic procedures?
A 3-day pass is $9.95 one-time and gives full access to all brands, codes, and procedures. Monthly access is $29/month with unlimited access to everything including Max AI diagnostics.