Frigidaire Range Error Code F69

F69 indicates that the range has detected a high voltage condition, typically caused by L1 or L2 being crossed with the neutral wire on the incoming power supply. The control board triggers this fault to protect the appliance from operating under dangerous electrical conditions. The first step is to verify proper voltage and polarity at the range's terminal block using a multimeter.

No. The F69 fault indicates a potentially dangerous wiring condition where voltage levels inside the appliance may be abnormal. Continuing to operate the range under these conditions risks damage to internal components and poses a serious electrical safety hazard. The range should remain unplugged until the wiring issue is diagnosed and corrected.

If the fix is simply correcting a miswired terminal block connection, the cost may be minimal, covering only a service call fee in the range of $75 to $150. If the wiring issue is at the wall outlet or panel and requires an electrician, expect to pay $100 to $300 depending on the complexity of the work. In the unlikely event the control board needs replacement, parts and labor combined typically range from $200 to $450.

If you are comfortable working with electrical wiring and can safely disconnect the range from power, you can inspect the terminal block connections and compare them to the wiring diagram on the back of the range. However, if the problem extends to the wall outlet, junction box, or electrical panel, a licensed electrician should perform that work. Never inspect or adjust wiring while the range is connected to power.

Resetting the range by disconnecting power briefly may temporarily clear the code, but the fault will return as soon as the range is powered back on if the underlying wiring issue has not been corrected. The F69 code is triggered by a condition the control board detects at startup, so no reset will permanently resolve it without fixing the root cause.