GE Oven Error Code ERROR

On a GE oven, ERROR is a control-level alert that appears in two situations: when a temperature below 80°F or above 199°F is entered during the Temp Cook function, or when the oven door is opened during an active Auto Cook cycle. It is not a component failure or sensor fault. The oven is simply rejecting an invalid command or an unexpected operating condition.

Yes, the ERROR code on a GE oven does not indicate any electrical or mechanical hazard. It is a software-level input validation message. Once you clear the error using the CLEAR/OFF pad or close the door and press START, the oven is safe to operate normally.

The ERROR code on a GE oven is a user input or door-state issue, not a hardware failure, so there is typically no repair cost at all. If the error is caused by a door that will not close properly and a worn door gasket or latch needs replacement, parts and labor could range from around $30 to $150 depending on the component and your local service rates.

For the Temp Cook function, press the CLEAR/OFF pad to reset the display, then re-enter your desired temperature making sure it falls between 80°F and 199°F. For the Auto Cook function, close the oven door and press the START pad immediately to resume the cycle. No tools or parts are needed for either fix.

In most cases, simply pressing the CLEAR/OFF pad is enough to clear the ERROR display without needing to disconnect power. If the display does not respond, you can reset the control by switching off the oven's circuit breaker for 30 seconds, then restoring power. After that, re-enter your cooking settings within the valid temperature range.