mypros+
Error code reference

GE Oven Error Code F2

Double Line Break Relay is ON in a non-cooking/clean mode, or failed component on control. Also indicates oven over temperature condition (door unlocked oven exceeded 600°F, door locked oven exceeded 925°F for ERCII/RS4800/RS5800, or 960°F for TO7). Also triggered by open thermal switch or both lock switches 1 & 2 closed at the same time.

SourceGE Oven - Service Manual: JKP13G0P1BGp. 24, 38, 51

GE codesGE oven codes
Diagnostic procedure

The full F2 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
For ERCII with key pads built in: repeat mode of operation, if failure re-occurs replace control. For separate key pads: push CLEAR/OFF, disconnect ribbon cable and wait 32 seconds to see if code re-occurs. For over temp: look for welded relay contacts on bake or broil relays. If over temp did not occur: look for high resistance connection in sensor circuit, check thermal switch, check fan operation.

SourceGE Oven - Service Manual: JKP13G0P1BGp. 24, 38, 51

Unlock with pass
Unlock with pass
Unlock with pass
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F2 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

38 manuals in the MyPros+ library document this code for GE oven.

Models covered by the manuals that document this code

More models are covered than are listed here.

Related GE oven error codes

All GE oven codes

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax