GE Washer Error Code 0

Code 0 on a GE washer means there are no stored fault codes in the control board's memory. It only appears when the washer is placed into Service Mode for diagnostic purposes. This is a status indicator, not an error condition, and no repair is needed based on this code alone.

Yes, code 0 does not indicate any hazard or malfunction. Since it simply means no faults are present in the control board's memory, the washer is safe to operate normally. If you are seeing this code, it was most likely displayed during a Service Mode session and not during a normal wash cycle.

Code 0 is not a fault that needs to be cleared. It is simply the system's way of reporting that no fault codes exist. Resetting the washer or clearing the fault memory will not change this result since the log is already empty. If other fault codes appear in the future, they can be cleared through the Service Mode interface.

No repair is required based on code 0 itself. The code confirms that the washer's control board has not logged any electronic faults. If the washer is still exhibiting a problem, that issue may be mechanical rather than electronic, and a technician should investigate further using standard diagnostic procedures.

There is no cost associated with code 0 because it is not a fault condition and requires no parts or repairs. If a technician entered Service Mode and found code 0, it means the diagnostic check came back clean. Any service call costs in this scenario would relate to the technician's time for the visit, typically in the range of $75 to $150 for a diagnostic fee.