GE Washer Error Code 06

Error code 06 on a GE washer indicates a lid lock fault. The control has detected that the lid lock will not engage or disengage properly, or it is reading the lock as engaged while the lid is physically open. The washer stops operation as a safety precaution until the issue is resolved.

No, you should not attempt to run the washer while error code 06 is active. The lid lock system is a safety feature designed to prevent access to the tub during high-speed spin cycles. If the lock is not functioning correctly, the washer could spin with an unsecured lid, creating a risk of injury.

If the repair requires a new lid lock assembly, the part typically costs in the range of $20 to $60 depending on the specific model, with professional labor adding $75 to $150 or more depending on your area. If the fault is simply a loose connector or misaligned lid strike, the cost can be minimal. An IMC board replacement, if needed, is significantly more expensive.

Some causes of error code 06 are DIY-friendly, such as inspecting and realigning a misaligned lid strike or checking for visible wiring damage. If the lid lock assembly itself has failed, replacing it is a moderately straightforward repair that requires disconnecting the wiring harness and removing a few fasteners. Continuity testing at the IMC connector requires a multimeter and some familiarity with electrical diagnostics.

A reset may temporarily clear the error display, but it will not resolve the underlying hardware fault. If the lid lock assembly, switch, or wiring is defective, the error code will return as soon as the control attempts to engage or read the lock again. The root cause must be diagnosed and repaired for the error to clear permanently.