mypros+
Error code reference

Indesit Washer Error Codes

16 error codes documented with diagnostic procedures.

Have your model number? Get codes specific to your unit.
F01Motor triac short circuit on main PCB or feedback fault.F02Motor jammed or tacho generator detached/open circuit/short circuit.F03NTC wash thermistor short or open circuit.F04Pressure switch jammed on empty.F05Pressure switch jammed on full or drain pump blocked; pressure switch empty condition not…F06Door lock fails to close/open, door lock PTC triac open/closed, mains frequency or power…F07Wash heating element relay stuck open or diverter relay sticking on drain pump side.F08Wash heating element relay earth leakage or relay contacts sticking.F09EEPROM setup/setting file error detected by Main PCB or Display PCB.F10Pressure switch not sensing.F11Pump cannot be activated; pump not wired or pump driving triac short circuit.F12No communication between Main PCB and Display PCB.F13NTC dryer sensor open or short circuit.F15Dryer heating element ground fault/short circuit or board relay sticking.F17Door lock error.F18Communication error between microprocessor on main module and DSP driving three phase…

Get the full diagnostic procedure for any code

Step-by-step tests, expected values, wiring diagram references, and verified part numbers.

Get Started $9.95 3-day pass

$29/month for unlimited access to all brands and Max AI diagnostics.

More Indesit error codes

Common questions

How do I find the error code on my Indesit Washer?
Most Indesit washers show the code directly on the control panel display. If your model has no display, it can be read by entering diagnostic mode with the key sequence for your model. The full procedures include model-specific instructions for reading codes.
Are these codes specific to my model?
The codes here apply broadly to Indesit washers. Meanings and diagnostic steps can vary by model and production year, so enter your model number for model-specific information and procedures.
What do I do if my code is not listed?
Some codes are model-specific or only appear in diagnostic mode. Enter your model number to get codes specific to your unit, or contact us. We update the database continuously from manufacturer service documentation.
How much does it cost to access the full diagnostic procedures?
A 3-day pass is $9.95 one-time and gives full access to all brands, codes, and procedures. Monthly access is $29/month with unlimited access to everything including Max AI diagnostics.