Indesit Dryer Error Codes

16 error codes for Indesit dryer models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

F01The motor is running when it should be off.F02Open circuit between module and motor Common.F03Front thermistor open or short circuit.F04Pump working when it should be off.F05Pump is not working when it should be on.F07Lower element failure or heater plug not connected to module.F08Lower element is energised when it should be off.F09Error Set Up File F10Open circuit in the heater Common wiring.F11Open circuit pump circuit.F12No communication between display module and control module.F13Rear thermistor open or short circuit.F14Upper element failure.F15Upper element is on when it should be off.F17Master Relay contacts welded closed.H20Water container is full

MyPros+ Max

Get the full diagnostic procedure for any Indesit dryer error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Indesit Dryer

F01 on my Indesit Dryer

M+

The motor is running when it should be off

From Service Manual 612255, p.27:

1.Check if module connector J3 has shorted due to moisture.

2.Measure the drive motor winding resistance at the main control connector. Expected: 2 to 6 ohms between winding pairs.

3.Rotate the drum by hand and check for free rotation. Inspect the belt and pulley for glaze or wear; a slipping belt mimics a motor fault under load.

Part W10006384

Drive motor

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started