Kenmore Washer Error Code E35

E35 indicates that the pressure sensor has detected a water overfill condition inside the wash tub. The sensor monitors water level by measuring air pressure through a hose connected to the tub, and E35 triggers when the level is read as exceeding approximately 4.5 inches. This could reflect a true overfill caused by a faulty inlet valve, or a false reading caused by a problem with the pressure sensor or its hose.

No, you should stop using the washer until the cause is identified. If the tub is genuinely overfilling, continuing to run the machine risks water overflowing onto the floor and causing water damage. Even if the reading turns out to be a false error, running the washer while a fault is active can stress other components.

Repair costs vary depending on the failed component. A replacement water inlet valve typically runs between $25 and $80 for the part, while a pressure sensor generally costs between $15 and $50. If you hire a technician, expect to add labor costs in the range of $80 to $150 per hour depending on your area. A hose inspection and cleaning, if that is the only issue, may cost little to nothing if done yourself.

Some causes of E35 are DIY-friendly. Inspecting and clearing a clogged or kinked pressure sensor hose or reattaching a disconnected hose requires no special tools or parts. However, replacing a faulty water inlet valve or pressure sensor involves working with water connections and electrical components, which many homeowners prefer to leave to a qualified technician.

A reset may temporarily clear the code, but if the underlying cause is not corrected, the error will return during the next fill cycle. A reset does not fix a faulty inlet valve, a blocked pressure hose, or a defective pressure sensor. Diagnose the root cause using Test 6 before relying on a reset as a solution.