mypros+
Model reference

Kenmore 41744052400

Washer

1 document37 error codes3 service modes

Available documentation

Service Manual

  • Source 417 Front Load Washer93 pg
    Covers this model
MyPros+ Max

Diagnose your Kenmore 41744052400.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (37)

CodeMeaning
E11Fill time too longE13Water leak in tub or air leak in air bell.E14Reed switch faultE21Water not pumping out fast enough.E23Drain pump relay on control board failed.E24Drain pump relay on control board failed.E31Better modelsE35Better modelsE41Control board thinks the door switch is open.E42Door remains locked after cycle is completed.E43Board communications problem.E44Board communications problem.E45Board communications problem.E46Board communications problem.E47Board thinks the door PTC circuit is open in spin.E48Board thinks the door PTC circuit is closed.E52No signal from tachogenerator.E55Motor overheating.E56High motor current.E57High current on inverter.E58High current on motor phase.E59No tacho signal for 3 seconds.E5AHigh temperature on heat sink.E5BHigh temperature on heat sink.E5CHigh temperature on heat sink.E5DCommunication problem between control board and speed control board.E5ECommunication problem between control board and speed control board.E5FCommunication problem between control board and speed control board.E67Input voltage on microprocessor incorrect.E75Better models only
View all 37 error codes
E76Better models onlyE95Communication error.EB1Incoming power frequency out of limits.EB2Incoming line voltage above 130 VAC.EB3Incoming line voltage below 90 VAC.EF1Clogged drain pump.EF2Too much detergent / oversudsing.

Service modes (3)

  • Clear Stored Error Code["Place the control into Diagnostic Test Mode.","Turn the program knob clockwise 9 clicks from the…
  • Diagnostic Test["Turn the Program Knob to the start position (Drain/Spin).","Press Pause/Cancel to turn off…
  • Error Code Recall["Wake the machine by pressing any button.","Wait 5 seconds.","Press and hold the Start and…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Kenmore washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax