Kenmore Washer Error Code E44

E44 on a Kenmore washer indicates a board communications problem. The main control board has lost the ability to communicate properly with one or more systems in the washer. This prevents the machine from operating safely and completing its cycle. The primary corrective action is to replace the control board.

A reset may temporarily clear the E44 code, but if the underlying cause is a failing control board, the error will return once the washer attempts to run again. Resetting is not a long-term fix for a communications fault of this type. The board should be inspected and replaced to resolve the problem permanently.

If the repair involves only reconnecting a loose wire harness connector, there is no parts cost. If the control board needs replacement, parts alone typically range from $100 to $300 depending on the specific model, with professional labor adding another $80 to $200. Total repair costs can range from $150 to $500 when using a service technician.

A knowledgeable DIYer can address this error by first checking that all wire harness connectors to the control board are fully seated and free of corrosion. If the connections look good, the repair requires replacing the control board, which involves disconnecting the unit from power, accessing the board housing, and swapping in a compatible replacement board. If you are not comfortable working with appliance electronics, a professional technician is recommended.

It is not recommended to continue using the washer while the E44 error is active. A board communications failure means the machine cannot reliably control its functions, which could result in unexpected behavior such as incorrect water fill, spin issues, or failure to stop. Discontinue use until the fault is resolved.