Error code reference

Lennox HVAC Error Code DIAG1 Flash Alternate, DIAG2 Flash Alternate

Flame failure detected (LED pattern exists during postpurge prior to Watchguard).

SourceLennox CompleteHeat HM30/AM30 - Service Manualp. 15, 41

Diagnostic procedure

The full DIAG1 Flash Alternate, DIAG2 Flash Alternate procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

Proceed with flame failure troubleshooting flowchart.

SourceLennox CompleteHeat HM30/AM30 - Service Manualp. 15, 41

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock DIAG1 Flash Alternate, DIAG2 Flash Alternate procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

1 manual in the MyPros+ library documents this code for Lennox hvac.

Models covered by the manuals that document this code

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full DIAG1 Flash Alternate, DIAG2 Flash Alternate procedure

Where this code is documented

Models covered by the manuals that document this code

Related Lennox hvac error codes