LG Dishwasher Error Code FC

The FC code means the dishwasher's dry fan motor measured less than 100 RPM during the drying cycle, and the control board was unable to recover after three retry attempts. The fan motor is responsible for circulating air to dry dishes after the wash cycle. This fault causes the dishwasher to stop operating until the underlying issue is resolved.

No. When the FC code is active, the dishwasher has already halted the cycle because the drying fan is not functioning correctly. Attempting to force the unit to continue operating without resolving the fault can result in poor drying performance and may mask an underlying electrical problem. The dishwasher should be inspected and repaired before regular use resumes.

Repair costs vary depending on the cause. If only a connector needs reseating, the cost may be limited to a service call fee, typically in the range of $75 to $150. Replacing the dry fan motor itself generally brings the total repair cost to somewhere between $150 and $300 including parts and labor. A control board replacement, if needed, can push costs higher, often ranging from $250 to $400 or more.

Some FC errors are caused by loose wiring connections that a careful DIYer can reseat after disconnecting power to the unit. However, diagnosing a failed motor coil or faulty control board requires a multimeter and comfort working with appliance wiring. If connections look intact and the motor does not spin freely by hand, the repair will likely involve replacing the fan motor, which is better suited for a technician.

A reset may temporarily clear the displayed code, but the FC fault will return if the underlying fan motor or wiring problem has not been corrected. The control board requires the fan motor to sustain at least 100 RPM, and it will retry and re-trigger the code if the root cause remains. A reset is useful only for confirming whether a transient glitch caused the fault, not as a permanent fix.